Roller Shutter Technical Measurement Calculator
Roller Shutter Measurement Calculator
Technical Order Specification Tool
Call us direct
02089116000
⚠ All Left / Right directions on this form are viewed from OUTSIDE looking IN

Choose Your Installation Type

Select how the shutter will be fitted to your wall. Not sure? Call us on 02089116000.

Option A — Most Common
Surface Fit (Face Fix)
The box and guides mount flat on the external wall face, completely overlapping the opening. No depth needed inside the reveal. Maximum light and access preserved.
Select Surface Fit →
Option B — Flush Finish
Fully Recessed (Reveal Fit)
Box and guides fit entirely inside the brickwork. Neater external appearance. Requires minimum 50mm reveal depth. Reduces walkthrough width and height.
Select Recessed Fit →
Surface Fit (Face Fix)
1
Width
2
Height
3
Motor
4
Spec
1
Measure the Width
Measure in 3 places — enter the LARGEST number
① TOP ② MIDDLE ③ BOTTOM Scale DAYLIGHT HEIGHT DAYLIGHT WIDTH
Measure top, middle & bottom — use the LARGEST
mm
Enter in millimetres. Typical shopfront: 1800–3000mm.
Surface Fit: Use the largest of your three measurements. The shutter must cover the widest point.
2
Measure the Height
Floor to underside of lintel — enter the LARGEST number
LINTEL FLOOR LEVEL SHUTTER BOX 310mm height 310 mm 80mm curtain YOUR MEAS- URE
Side profile — floor to underside of lintel
mm
Measure floor to underside of lintel. Typical: 2000–2500mm.
Surface Fit: We add 310mm for the box above the lintel and 80mm for the curtain overhang below automatically.
3
Motor & Guide Rail Position
⚠ Directions are OUTSIDE looking IN — stand outside and look at the shutter
← OUTSIDE (Standing here, looking in) → External Wall 80mm Non-motor 80mm M 120mm MOTOR side 120mm 50mm depth Shutter curtain (laths) ← INSIDE (your premises) → LEFT RIGHT (outside view) (outside view)
Bird's-eye view — outside looking in
Stand outside facing the shutter. Which side is the motor on?
Why does the motor side matter?
The motor requires a wider 120mm guide rail to accommodate the electrical drive mechanism. The non-motor side uses an 80mm guide. Selecting the wrong side will cause a mis-build.
4
Specification & Site Conditions
Complete your order specification
Standard commercial shopfront lath. 75mm pitch galvanised steel.
All shutters are electric. Manual override chain included as standard.
Enter RAL number. Colour-match surcharge applies — confirm with us before ordering.
unit(s)
Manufacturing Order Summary
REF: —
Fit Type
—
Motor Side (Outside view)
—
Slat / Curtain Type
—
Control Type
—
Finish / Colour
—
Wall Substrate
—
Customer Input Size
—
Quantity
—
Manufacturing Order Size
— mm
— mm
Enter measurements above
Clear Walkthrough Opening
— mm
— mm
width after guides deducted
Enter your width and height measurements above to see both the manufacturing size and your actual clear walkthrough opening.